48
GB
Change of door opening direction
Should the setting-up place or handling demand it,
door-opening direction can be refitted from right-hand-
ed to left-handed.
Following operations are to be done on the basis of fig-
ures and explanations:
Break the circuit of the appliance.
Tilt back the appliance carefully being careful so that
the compressor can not touch the floor. It is recom-
mended to ask another person for help, who can
keep the appliance at this position safely.
Unscrew the adjustable feet situated on both sides
(2 pieces), in addition the screws fixing the lower
door holders (3 pieces) and the screw on the other
side respectively.
Put over the pin in the lower door holding plate in the
direction of the arrow.
Take the door off.
Unscrew the top door holding pin and put it on the
other side.
Fit the door to the top door holding pin.
Fix the bottom door holders on the other side being
careful that the edge of the door is parallel with the
side of cupboard.
Then screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces) and set up the box.
Put over the handle and the plastic nails on the other
side.
Put the appliance to its place, set it level and apply
voltage to it.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Electrical connection
This refrigerator is designed to operate on a 230 V
AC (~) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to
get an electrician to fit an earthed socket in compli-
ance with standards near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
- 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent modifica-
tions.
Comentarios a estos manuales